CeilAir CW series Betreibershandbuch PDF herunterladen (Seite 14)

(©July, 2008)

CeilAiR OHS Series Installation, Operation & Maintenance Manual

ir Technology Systems, Inc.

2-3

NOTE

SATS supplied thermostats/controls do not con-

tain mercury.

Mount the thermostat upright on an inside wall within

the conditioned room that best represents the average

room temperature. In most cases, the thermostat

should be located near the common return air grille.

Mount the thermostat at least 18 inches from an

outside wall and approximately 5 ft. above the floor.

Follow the steps below to mount. Instructions for

wiring the unit and setting the dip switches are

provided in Section 2.7, Utility Connections.

1. Unlatch the thermostat from the base. Remove

the cover plate and, using a flat head screwdriver,

gently insert into the latch access slot (bottom of

base) until the lock tab disengages.

2. Pry up the handle of the screwdriver to separate

the thermostat panel from the base. Grip the

bottom corners of the thermostat panel to remove

from base.

3. Place the base temporarily over the wire hole

opening in the wall. Level the base and mark

location through the two provided mounting slots.

CAUTION

Do not touch the temperature sensor on the bot-

tom left corner of the thermostat. The sensor

can be damaged if handled improperly.

4. If using the supplied anchors, drill two 3/16 inch

holes, tap in wall anchors. If only the supplied

screws are being used, drill two 3/32 inch holes.

5. Fasten the base to the wall using the supplied

screws.

6. Reinstall thermostat to base.

2.4.3.2 Humidistat/Dehumidistat (Optional Sup-

plied with A-Tech-1.1/1.2 Thermostat)

Mounting of the humidistat and dehumidistat is

performed in the same manner. Mount the humidistat

and/or dehumidistat (as described in Section 2.4.3.1)

to a wall within the conditioned room that best repre-

sents the average humidity of the space. In most

cases, the humidistat and dehumidistat should be

located near the common return air grille. Mount the

humidistat and dehumidistat at least 18” from an

outside wall and approximately 5 ft. above the floor.

Controls may be installed either on a flush switch box

or on a surface switch box. Follow the steps below to

mount. Instructions for wiring of unit are are provided in

Section 2.7, Utility Connections.

1. Pull dial knob off, loosen screw (located at bottom

of unit) and remove cover.

2. Make wiring connections (see Section 2.7).

3. Mount with the two #6 screws provided.

4. For external setpoint, reinstall cover, tighten

screw, and replace dial knob.

5. For internal setpoint:

a. Turn dial plate to desired setting and tighten

dial lock screw.

b. Break off dial shaft at undercut.

c. Remove insert from cover.

d. Remove protective backing from adhesive on

the blank insert provided and press firmly in

place on cover.

e. Reinstall cover assembly and tighten screw. (If

additional security is required an Allen screw

and wrench are provided.)

f. Remove protective cover from face of cover

insert.

2.4.3.3 Advanced Controllers

(C-Tech 10, A-Tech-20 or C6000)

If you purchased this option, a separate manual is

sent in the unit data package affixed to your unit. Refer

to that manual and the electrical drawing(s) provided

when mounting the controller display. The controller

display may be field mounted to a wall within the

conditioned space or it may be located outside the

conditioned space if desired. When locating the

sensor, consider the length of wire to be used. As an

option, a 30 foot, 75 foot or 150 foot long cable may be

provided by SATS.

2.4.4 Optional Equipment

NOTE

Do not mount any optional equipment on the

A/C unit’s access panels.

2.4.4.1 Transformer

The buck/boost transformer provided is encapsulated

and can be installed indoors or outdoors. If installed

outdoors, the unit should be installed with the wiring

compartment down to prevent entrance of moisture.

For indoor floor installation the unit may be installed

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare

CeilAir CW series Betreibershandbuch Seite 14

Kommentare zu diesen Handbüchern